Siemens TC63 Command Set page 285

TC63 AT Command Set
11.8 AT+CGEQREQ
<Maximum SDU size>
This parameter indicates the maximum allowed SDU size in octets.
[0]
10...1520
1502
(str)
<SDU error ratio>
This parameter indicates the target value for the fraction of SDUs lost or detected as erroneous. SDU error ratio
is defined only for conforming traffic. The value is specified as "mEe". As an example a target SDU error ratio
-3
of 5*10 would be specified as "5E3" (e.g. AT+CGEQREQ=...,"5E3",...).
["0E0"]
"1E2"
"7E3"
"1E3"
"1E4"
"1E5"
"1E6"
"1E1"
<Residual bit error ratio>
This parameter indicates the target value for the undetected bit error ratio in the delivered SDUs. If no error
detection is requested, Residual bit error ratio indicates the bit error ratio in the delivered SDUs. The value is
specified as "mEe". As an example a target residual bit error ratio of 5*10
AT+CGEQREQ=...,"5E3",...).
["0E0"]
"5E2"
"1E2"
"5E3"
"4E3"
"1E3"
"1E4"
"1E5"
"1E6"
"6E8"
<Delivery of erroneous SDUs>
This parameter indicates whether SDUs detected as erroneous shall be delivered or not.
0
1
2
[3]
TC63_ATC_V00.490
Confidential / Draft - Do not copy
(num)
subscribed value
(value needs to be divisible by 10 without remainder)
subscribed value
(str)
subscribed value
(num)
no
yes
no detect
subscribed value
Page 285 of 501
s
-3
would be specified as "5E3" (e.g.
5/24/05