At^sstgi Sat Get Information - Siemens TC63 Command Set

TC63 AT Command Set
16.3 AT^SSTGI
16.3

AT^SSTGI SAT Get Information

Regularly this command is used upon receipt of an URC "^SSTN" to request the parameters of the Proactive
Command.
Then the TA is expected to acknowledge the
Command has been executed.
The Proactive Command type value specifies to which "^SSTN" the command is related.
Syntax
Test Command
AT^SSTGI=?
Response(s)
^SSTGI:(list of supported <state>s), (list of supported <cmdType>s)
OK
Read Command
AT^SSTGI?
Response(s)
^SSTGI: <state>, <cmdType>
OK
Write Command
AT^SSTGI=<cmdType>
Response(s)
OK
ERROR
+CME ERROR
Reference(s)
SIEMENS
Parameter Description
(num)
<state>
TC63 Remote-SAT interface states
0
1
2
3
4
(num)
<cmdType>
Related Proactive Command
TC63_ATC_V00.490
Confidential / Draft - Do not copy
AT^SSTGI
will also provide any user information, e.g. a selected menu item.
AT^SSTR
PIN
!
RESET
OFF
IDLE
PAC
WAIT
Page 389 of 501
response with
AT^SSTR
ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
% % % %
s
to confirm that the Proactive
Last
% % ! %
5/24/05
!