Responses Returned By Read Command - Siemens TC63 Command Set

TC63 AT Command Set
19.3 AT^SBC
Notes
• If multiplex mode (AT+CMUX) is active, any virtual channel can be used for entering the read or write com-
mand. The undervoltage URC will be issued simultaneously on all three channels.
• The URC "^SYSSTART CHARGE ONLY
(except when autobauding is active). Unlike the undervoltage URC, it cannot be disabled or enabled by the
TE.
19.3.1

Responses returned by read command

Responses returned by the
• Normal mode: TC63 is switched on by Ignition pin and running in SLEEP, IDLE, TALK or DATA mode.
Charger is not connected. The
sumption of the application (if value of application was specified before as <current>).
• Normal mode + charging: Allows charging while TC63 is switched on by Ignition pin and running in SLEEP,
IDLE, TALK or DATA mode. The
tion of the application. Percentage of battery capacity is not available.
• CHARGE ONLY mode: Allows charging while TC63 is detached from GSM network. When started, the mode
is indicated by the URC
charger status and current consumption of the application. Percentage of battery capacity is not available. In
CHARGE ONLY mode a limited number of AT commands is accessible (see Appendix). There are several
ways to activate the CHARGE ONLY mode:
- from POWER DOWN mode: Connect charger while the TC63 was powered down with
- from Normal mode: Connect charger, then enter AT^SMSO.
TC63_ATC_V00.490
Confidential / Draft - Do not copy
MODE" is indicated automatically when the module enters this mode
read command vary with the operating mode of the TC63:
AT^SBC
read command indicates the battery capacity and the current con-
AT^SBC
read command returns only charger status and current consump-
AT^SBC
"^SYSSTART CHARGE ONLY
Page 442 of 501
MODE". The read command returns only the
AT^SBC
s
AT^SMSO
5/24/05