At+Cpin2 Pin2 Authentication - Siemens TC63 Command Set

TC63 AT Command Set
5.2 AT+CPIN2
5.2

AT+CPIN2 PIN2 Authentication

controls network authentication of the TC63.
AT+CPIN2
The read command returns an alphanumeric string indicating whether or not network authentication is required.
The write command allows the TC63 to store the entered password. This may be for example the SIM PIN2 to
benefit from the features listed below, or the SIM PUK2 to replace a disabled PIN2 with a new one. Note that
PIN2 can only be entered if PIN1 authentication was done.
If the TC63 is requesting SIM PUK2, use
PIN2.
Syntax
Test Command
AT+CPIN2=?
Response(s)
OK
Read Command
AT+CPIN2?
Response(s)
+CPIN2: <code>
OK
ERROR
+CME ERROR: <err>
Write Command
AT+CPIN2=<pin>[, <new
Response(s)
OK
ERROR
+CME ERROR: <err>
Reference(s)
GSM 07.07
Parameter Description
(str)
<pin>
Password (string type), usually SIM PIN2 or, if requested, SIM PUK2.
(str)
<new pin>
If the requested code was SIM PUK2: new password (PIN2).
See Section 5.1.1, What to do if PIN or password authentication fails?
need to enter the PUK.
(text)
<code>
READY
SIM PIN2
SIM PUK2
TC63_ATC_V00.490
Confidential / Draft - Do not copy
to enter the PUK2, followed by
<pin>
pin>]
PIN
ME is not pending for any password.
ME is waiting for SIM PIN2.
This is returned only when PIN2 authentication has not yet been done
<code>
or has failed ("+CME ERROR:17").
ME is waiting for SIM PUK2.
This is returned only when PIN2 authentication has failed and ME is
<code>
pending for SIM PUK2 (i.e. "+CME ERROR:18").
Page 112 of 501
ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
% % % % %
for more information about when you may
s
to specify the new
<new pin>
% % ! %
5/24/05
Last
!