At^saic Audio Interface Configuration - Siemens TC63 Command Set

TC63 AT Command Set
18.8 AT^SAIC
18.8

AT^SAIC Audio Interface Configuration

configures the interface connections of the active audio mode. The write command is usable in audio
AT^SAIC
modes 2 to 6 only.
If AT^SNFS=1, any attempt to use
default parameters in audio mode 1 are determined for type approval and are not adjustable.
To allocate a specific audio mode to one of the audio interfaces, first select the audio mode with
then choose the interface using AT^SAIC.
Syntax
Test Command
AT^SAIC=?
Response(s)
^SAIC:(list of supported <io>s), (list of supported<mic>s), (list of supported<ep>s)
OK
Read Command
AT^SAIC?
Response(s)
^SAIC: <io>, <mic>,
OK
Write Command
AT^SAIC=<io>[, <mic>[, <ep>]]
Response(s)
OK
ERROR
+CME ERROR: operation not allowed
Reference(s)
SIEMENS
Parameter Description
(num)(^SNFW)
<io>
Input and output selection
1
2
(num)(^SNFW)
<mic>
Microphone selection
1
2
(num)(^SNFW)
<ep>
Select differential earpiece amplifier
1
2
3
TC63_ATC_V00.490
Confidential / Draft - Do not copy
write command is rejected with error response. This is because all
AT^SAIC
<ep>
Digital input and output
Analog input and output
Microphone 1
Microphone 2
Selects the earpiece amplifier 1
Selects the earpiece amplifier 2
Selects both amplifiers. Note that both amplifiers are connected in parallel and
therefore, get the same output power if <ep>=3.
Page 417 of 501
PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
! % % %
s
AT^SNFS
% % % !
and
Last
% !
5/24/05