Ats18 Extended Call Release Report - Siemens TC63 Command Set

TC63 AT Command Set
3.5 ATS18
3.5

ATS18 Extended call release report

controls the presentation of extended call release reports for circuit switched fax and data calls. Extended
ATS18
call release reports related to voice calls are controlled via AT+CEER.
The call release report is presented in numeric format and shows as follows:
+CAUSE: <locationID>:<reason>
If enabled the message will be reported every time a fax or data call is released or fails to be established.
Syntax
Read Command
ATS18?
Response(s)
<n>
OK
Write Command
ATS18=<n>
Response(s)
OK
ERROR
Reference(s)
V.250
Parameter Description
(num)(&W)(&V)
<n>
An odd number enables the presentation of the extended call release report. Any even number disables this
feature.
(&F)
0 ...255
(num)
<locationID>
Location ID as number code, see also
Location IDs are listed in Section 3.4.1,
another table that contains a list of <reason>s.
(num)
<reason>
Reason for last call release as number code (see also
numbers and the associated descriptions are listed in several tables, sorted by different categories
<reason>
at AT+CEER. The tables can be found proceeding from the Location IDs listed in Section 3.4.1,
ID for the extended error
TC63_ATC_V00.490
Confidential / Draft - Do not copy
<locationID>
Cause Location ID for the extended error
report.
Page 85 of 501
PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
! % ! %
of AT+CEER.
of AT+CEER).
<reason>
s
% ! ! !
report. Each ID is related to
Cause Location
Last
% !
5/24/05