Siemens TC63 Command Set page 408

TC63 AT Command Set
17.10 AT^SPBS
(num)
<index-b>
1...maxindex
(num)
<index-c>
1...maxindex
(str)
<number>
String type phone number in format specified by <type>.
the number parameter may be an empty string.
(num)
<type>
Type of address octet, which defines the used type of number (ton) and the numbering plan identification (npi).
Please consider that for types other than 129 or 145 dialing from phonebook with
on the network, not always possible (refer to GSM 04.08 subclause 10.5.4.7 for details). See also
AT+CPBW.
Possible values are:
145
161
209
255
129
(str)(+CSCS)
<text>
Text assigned to the phone number.
(num)
<RealLocReq>
Is a display of the "real"
[0]
1
(num)
<location>
The location within phonebook memory at which the corresponding entry is located.
This location may be used for other phonebook commands (e.g. AT+CPBR, AT+CPBW, ATD><mem><n>).
TC63_ATC_V00.490
Confidential / Draft - Do not copy
After a write command has terminated successfully with "OK", the value from
parameter
<index-a>
value.
counter>
Mind after the last record of phonebook, the first entry follows.
The index in the sorted list of phonebook entries that identifies the second entry
displayed.
<index-b>= (<index-a>+1).
Mind after the last record of phonebook, the first entry follows.
The index in the sorted list of phonebook entries that identifies the third entry
displayed.
<index-c>= (<index-b>+1).
Mind after the last record of phonebook, the first entry follows.
Dialing string
<number>
National number. Network support of this type is optional.
Dialing string
<number>
digit characters other than "*", "#" or "+". Note that phonebook entries saved
with this type cannot be dialed.
Dialing string
<number>
i.e. "*", "#" codes are contained. Network support of this type is optional.
Otherwise
of the entry required?
<location>
Do not show an entry's "real" location number. Parameter
be displayed
Show the "real" location number as parameter
entry
Page 408 of 501
is saved and retained as the new
ATD><mem><n>
includes international access code character '+'
has been saved as ASCII string and includes non-
is a command to control a Supplementary Service,
<location>
s
<internal-
is, depending
of
<type>
will not
<location>
at the end of the
5/24/05