Gprs Commands; At+Cgact Pdp Context Activate Or Deactivate - Siemens TC63 Command Set

TC63 AT Command Set

11. GPRS Commands

11. GPRS Commands
This chapter describes AT Commands that a TE (Terminal Equipment, e.g. an application running on a control-
ling PC) may use to control the TC63 acting as GPRS Mobile Termination (MT). Please use chapter
(Examples)" as a first guidance.
GPRS AT commands
11.1

AT+CGACT PDP context activate or deactivate

Syntax
Test Command
AT+CGACT=?
Response(s)
+CGACT: (list of supported <state>s)
OK
Read Command
AT+CGACT?
Response(s)
+CGACT: <cid>, <state>
[+CGACT: <cid>, <state>]
...
OK
Write Command
AT+CGACT=[<state>[, <cid>[, <cid>]]]
Response(s)
OK
ERROR
+CME ERROR
Reference(s)
GSM 07.07
Command Description
The test command is used for requesting information on the supported PDP context activation states.
The read command returns the current activation states for all the defined PDP contexts.
The write command is used to activate or deactivate the specified PDP context(s). After the command has com-
pleted, the MT remains in V.250 command state. If any PDP context is already in the requested state, the state
for that context remains unchanged. If the MT is not GPRS attached when the activation form of the command
is executed, the MT first performs a GPRS attach and then attempts to activate the specified contexts. If no
<cid>s are specified the activation/deactivation form of the command activates/deactivates all defined contexts.
Parameter Description
(num)
<state>
Indicates the state of PDP context activation.
0
[1]
TC63_ATC_V00.490
Confidential / Draft - Do not copy
PIN
%
deactivated
activated
Page 268 of 501
ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
% % % %
s
"Using
Last
% % ! ! !
5/24/05