Atz Set All Current Parameters To User Defined Profile; At&C Set Circuit Data Carrier Detect (Dcd) Function Mode - Siemens MC35 Command Set

AT Command Set

2.32 ATZ Set all current parameters to user defined profile

Execute command Response
ATZ[<value>] TA sets all current parameters to the user profile stored with AT&W (see Chapter
2.38 on page 43). If a connection is in progress, it will be terminated. All defined
GPRS contexts which are not activated or not online will be undefined (see
+CGDCONT,+CGQREQ,+CGQMIN commands). The user defined profile is
stored to the non-volatile memory.
Note: If invalid, the user profile will be reset to the factory default profile. Any ad-
ditional commands on the same command line will be ignored. A delay of 300 ms
is required before next command is sent, otherwise "OK" response may be cor-
rupted.
OK
Parameter
<value> 0 Reset to user profile
Reference Note
V.25ter
The GSM engines referred to in this manual can be assigned two profiles: the
factory profile (restored with AT&F) and the user profile (stored with AT&W). See
Chapter 2.35 for details on AT&F.
2.33 AT&C Set circuit Data Carrier Detect (DCD) function mode
Write command Response
AT&C[<value>]
This parameter determines how the state of circuit 109(DCD) relates to the detec-
tion of received line signal from the distant end.
OK
Parameter
<value>
Reference Note
V.25ter Line state refers to RS-232 levels.
MC35_ATC_01_V05.00
0 DCD line is always ON.
1 DCD line is ON in the presence of data carrier only.
Page 37 of 256 15.07.2002