At+Cmgc Send An Sms Command - Siemens TC63 Command Set

TC63 AT Command Set
13.2 AT+CMGC
13.2

AT+CMGC Send an SMS command

Syntax
Test Command
AT+CMGC=?
Response(s)
OK
Write Command
If text mode (see AT+CMGF=1)
AT+CMGC=<fo>, <ct>[, <pid>[, <mn>[, <da>[, <toda>]]]]
Response(s)
+CMGC: <mr>[, <scts>]
If sending fails
ERROR
+CMS ERROR
Write Command
If PDU mode (see AT+CMGF=0)
AT+CMGC=<length>
<CR>
Response(s)
+CMGC: <mr>[, <ackpdu>]
OK
If sending fails
ERROR
+CMS ERROR
Reference(s)
GSM 07.05
Notes
• After invoking the commands AT+CMGW,
before entering text or PDU. After the prompt a timer will be started to observe the input.
• At baudrates below 19200 it is recommended to use the line termination character only (refer to ATS3, default
) before entering the text or PDU. Use of the line termination character followed by the response format-
<CR>
ting character (refer to ATS4, default
TC63_ATC_V00.490
Confidential / Draft - Do not copy
PDU can be entered
<CTRL-Z>
PIN
AT+CMGS
can cause problems
<LF>
Page 324 of 501
Text can be entered
<CR>
/
<ESC>
ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
% % % % %
or it is necessary to wait for the prompt ">"
AT+CMGC
s
/
<CTRL-Z> <ESC>
Last
% % ! ! !
5/24/05