Ats10 Set Disconnect Delay After Indicating The Absence Of Data Carrier - Siemens TC63 Command Set

TC63 AT Command Set
7.16 ATS10
7.16 ATS10 Set disconnect delay after indicating the absence of data
carrier
Syntax
Read Command
ATS10?
Response(s)
<n>
OK
Write Command
ATS10=<n>
Response(s)
OK
ERROR
Reference(s)
V.250
Command Description
This parameter setting determines the amount of time, that the TA remains connected in absence of a data car-
rier. If the data carrier is detected before disconnect, the TA remains connected.
Parameter Description
(num)(&W)(&V)
<n>
number of tenths of seconds of delay
(&F)
001...2 ...254
TC63_ATC_V00.490
Confidential / Draft - Do not copy
PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
! % ! %
Page 158 of 501
s
% ! ! !
Last
% !
5/24/05