Configuration Commands; At&F Set All Current Parameters To Manufacturer Defaults - Siemens TC63 Command Set

TC63 AT Command Set

2. Configuration Commands

2. Configuration Commands
The AT Commands described in this chapter allow the external application to determine the TC63's behaviour
under various conditions.
2.1 AT&F Set all current parameters to manufacturer defaults
sets all current parameters to the manufacturer defined profile. All defined GPRS contexts which are not
AT&F
activated or not online will be undefined (see AT+CGDCONT).
Syntax
Exec Command
AT&F[<value>]
Response(s)
OK
Reference(s)
V.250
Parameter Description
(num)
<value>
[0]
Notes
• List of parameters reset to manufacturer default can be found in Section 21.6,
tings Restorable with
• In addition to the default profile, you can store an individual one with AT&W. To alternate between the two pro-
files enter either
ATZ
• Every ongoing or incoming call will be terminated.
TC63_ATC_V00.490
Confidential / Draft - Do not copy
Set all TA parameters to manufacturer defaults
AT&F.
(loads user profile) or
AT&F
Page 30 of 501
PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
! % % %
(restores factory profile).
s
% % % !
Factory Default Set-
Last
% !
5/24/05