Me Status Indicated By Status Led Patterns; Table 19.1: Modes Of The Led And Indicated Me Functions - Siemens TC63 Command Set

TC63 AT Command Set
19.6 AT^SSYNC
19.6.1

ME status indicated by status LED patterns

The following table lists the possible patterns of status LED behavior, and describes the ME operating status indi-
cated by each pattern if
AT^SSYNC

Table 19.1: Modes of the LED and indicated ME functions

LED behavior
Permanently off
600 ms on / 600ms off
75 ms on / 3 s off
75 ms on / 75 ms off /
75 ms on / 3 s off
500 ms on / 25 ms off
Permanently on
n * 600 ms on / n * 600 ms
off
TC63_ATC_V00.490
Confidential / Draft - Do not copy
parameter <mode>=1 and <mode>=2.
ME operating status if AT^SSYNC=1
ME is in one of the following modes:
POWER DOWN mode, AIRPLANE
mode, CHARGE ONLY mode, SLEEP
mode with no wake-up event is
progress.
Limited Network Service: No SIM card
inserted or no PIN entered, or network
search in progress, or ongoing user
authentication, or network login in
progress.
This applies no matter whether the ME
works at full functionality level
AT+CFUN=1 or has entered a "tempo-
rary wake-up state" during one of the
CYCLIC SLEEP modes.
IDLE mode: The mobile is registered to
the GSM network (monitoring control
channels and user interactions). No call
is in progress.
The same LED pattern applies when the
ME enters a "temporary wake-up state
during one of the CYCLIC SLEEP
modes (e.g. after characters have been
received on the serial interface).
One or more GPRS contexts activated.
Packet switched data transfer in
progress.
Depending on type of call:
Voice call: Connected to remote party.
Data call: Connected to remote party or
exchange of parameters while setting
up or disconnecting a call.
This applies no matter whether the ME
works at full functionality level
AT+CFUN=1 or in one of the CYCLIC
SLEEP modes where it wakes up only
temporarily to make the call.
Not possible: With AT^SSYNC=1, LED
signalization is disabled in SLEEP
mode.
Page 448 of 501
s
ME operating status if AT^SSYNC=2
ME is in one of the following modes:
POWER DOWN mode, AIRPLANE
mode, CHARGE ONLY mode.
Same as for AT^SSYNC=1
Same as for AT^SSYNC=1
Same as for AT^SSYNC=1
Same as for AT^SSYNC=1
Same as for AT^SSYNC=1
SLEEP mode is activated
≠ 1), but the ME is not
parameter
<fun>
registered to the GSM network (e.g. SIM
not inserted or PIN not entered, and
therefore, either no network service or
only Limited Network Service is avail-
able.
(AT+CFUN
5/24/05