Siemens TC63 Command Set page 248

TC63 AT Command Set
10.2 AT^SISS
pLength
pDelFlag
(str)
<srvParmValue>
Parameter value; type and supported content depend on related <srvParmTag>.
<srvParmValue-srvType>
Supported Internet service type values in
Before changing the "srvType" of an existing service profile be sure that the profile is closed. To verify the con-
nection state of the service profile enter the read command AT^SISO. Only when <srvState>=2 is returned
for this specific service profile you can change its server type. Otherwise, changing the server type would imme-
diately deregister the service (i.e. its TCP/IP connection would be immediately shut down).
"Socket"
"FTP"
"HTTP"
"SMTP"
"POP3"
"none"
TC63_ATC_V00.490
Confidential / Draft - Do not copy
Maximum message length (string, optional)
32
Length: 0 ... 2 -1
"pLength" can be used to specify the length of the message(s) to be retrieved
from or deleted on the POP3 server. If no specific value is set in the service
profile, the default value "0" is assumed, which means that there is no limit on
the message size.
A warning will be issued inthe following cases:
• If "pNumber" > 0 and a specific message to be retrieved from / deleted on
the server is longer than "pLength".
• If "pNumber" = 0 and all messages to be retrieved from / deleted on the
server are longer than "pLength".
No warning will be issued in the following cases:
• If there are no messages at all on the server.
• If the server has message(s) below and above the "pLength" specified. In
this case, the message(s) within the range of "pLength" can be successfully
retrieved or deleted, but the message(s) above "pLength" remain on the
server without any further notification given to the user.
• Therefore, after retrieving / deleting messages, it is recommended to check
the message status on the server. This can be done by adding a further
POP3 service profile using the POP3 user command List ("2").
Flag to be used with the POP3 user command Retrieve ("3"). Specifies whether
or not to delete retrieved emails on the server (optional).
For supported values of
pDelFlag>.
(str)
<srvParmValue>
TC63 acting as client or server (listener) for TCP, or as client for UDP.
If TC63 is listener two service profiles are required. The first socket profile must
be configured as listener. The second service profile will be dynamically
assigned when a socket connection request from a remote client is incoming.
For this purpose, one service profile must be left free (= not configured with
AT^SISS). An incoming socket connection request will be indicated by the
"^SIS" URC, with the next free
parameter <urcInfoId>. The connection request can be accepted or
rejected by using the commands
from the "^SIS".
TC63 acting as FTP client.
TC63 acting as HTTP client.
TC63 acting as SMTP client.
TC63 acting as POP3 client.
Reset Internet service profile settings. Operation is not allowed if profile is in
use, i.e. it was activated via AT^SISO.
Page 248 of 501
refer to
<srvParmValue>
for value "srvType".
<srvParmTag>
shown inside the URC as
<srvProfileId>
or
AT^SISO AT^SISC
s
<srvParmValue-
and the ID retrieved
5/24/05