Cfgenable - HP StorageWorks 8B - FC Entry Switch Reference Manual

cfgEnable

Enables a zone configuration.
Synopsis
cfgEnable "cfgName"
Availability
admin
Description
Use this command to commit any zone configuration in the transaction buffer to the volatile and
non-volatile memory and enable the specified zone configuration. This command ends the current
zoning transaction.
The specified zone configuration is built by checking for undefined zone names, zone alias names,
or other inconsistencies; by expanding zone aliases, removing duplicate entries, and then installing
the effective configuration.
If the build fails, the previous state is preserved (zoning remains disabled, or the previous Effective
configuration remains in effect). If the build succeeds, the new configuration replaces the previous
configuration.
Execute the cfgShow command for a description of defined and effective configurations.
If a transaction is open on a different switch in the fabric when this command is run, the transaction
on the other switch is automatically aborted. A message is displayed on the other switch notifying
the transaction abort.
Note:
Operands
This command has the following operand:
cfgName
Example
To enable the zone configuration "Test_cfg":
See Also
cfgClear
cfgDisable
cfgSave
cfgShow
Fabric OS Reference
This command requires a Zoning License.
Specify the name of a zone configuration in quotation marks. This operand is
required.
switch:admin> cfgEnable "Test_cfg"
zone config "Test_cfg" is in effect
1
Telnet Commands
1-23