HP StorageWorks 8B - FC Entry Switch Reference Manual page 63

The state of GBIC mode is saved in flash memory and remains active after reboots or power cycles
until it is disabled as follows:
switch:admin> setGbicMode 0
Operands This command has the following operands:
passCount
loopbackmode
speedmode
Fabric OS Reference
Specify the number of times (or number of frames per port) to execute this test.
This number can be entered in either decimal or hex. If omitted, the default value
is 0xfffffffe. This operand is optional.
Specify the loopback mode. Valid values are:
1 - for singleportalso mode
2 - for external loopback mode
5 - for internal loopback mode
Specify the speed of the connection to test. Valid values are:
0 - Auto negotiate
1 - 1GB
2 - 2GB
3 - odd ports 1g, even ports 1G
4 - odd ports 2g, even ports 1G
5 - even ports 1G, odd ports Auto negotiate
6 - even ports 2G, odd ports Auto negotiate
This operand is optional.
1
Telnet Commands
1-49