HP StorageWorks 8B - FC Entry Switch Reference Manual page 314

2
Error Messages
Table 2-4
Message
DIAG-LCMRS
Err#1F25, 1025
[centralMemoryTest,
cmemRetentionTest]
DIAG-LCMTO
Err#1F26, 1026
[centralMemoryTest,
cmemRetentionTest]
DIAG-MEMNULL
Err#0112
[ramTest]
DIAG-MEMSZ
Err#0111
[ramTest]
DIAG-MEMORY
Err#0110
[ramTest]
DIAG-NOSEGMENT
Err#3081,3881
[crossPortTest,
spinSilk]
DIAG-PORTABSENT
Err#2670, 3070, 3870
[portLoopbackTest,
crossPortTest, spinSilk]
DIAG-PORTDIED
Err#265F, 305F, 385F
[portLoopbackTest,
crossPortTest, spinSilk]
DIAG-PORTM2M
Err#3080, 3880
[crossPortTest,
spinSilk]
2-12
Diagnostic Error Messages (Continued)
Description
Central Memory Read Short: M bytes
requested but not received
Central Memory Timeout: Data transfer
initiated did not complete within the
timeout period
Test failed to malloc
Memory size to be tested is less than or
equal to zero
Data read from RAM location did not
match previously written data into same
location
Port failed to go into loopback mode
Port is not present
Port was in loopback mode and then
went inactive
Port is found to be connected to itself
(self loopback). This Port M to Port M
connection is not allowed by the test
Probable Cause Action
ASIC failure Replace mainboard
assembly
ASIC failure Replace mainboard
assembly
mainboard failure Replace mainboard
assembly
mainboard failure Replace mainboard
assembly
CPU RAM failure Replace mainboard
assembly or
DRAM module
Improper SFP or Reseat SFPs and
cable connection cables and
re-execute test
ASIC or mainboard Replace mainboard
failure assembly
ASIC, SFP module Replace mainboard
or fiber cable failure assembly, SFP
module or fiber
cable
Improper cable Reconnect port
connection (M) to another port
(N) and re-execute
the test
Fabric OS Reference