Cfgsave - HP StorageWorks 8B - FC Entry Switch Reference Manual

cfgSave

Save zone configuration to flash memory.
Synopsis
cfgSave
Availability
admin
Description Use this command to save the current zone configuration. The defined configuration and the name
of the enabled configuration are written to flash memory in all switches in the fabric.
The saved configuration is automatically reloaded by the switch on power up and, if a configuration
was enabled at the time it was saved, the same configuration is reinstalled with an automatic
cfgEnable command.
Because the saved configuration is reloaded at power on, only valid configurations are saved.
cfgSave verifies that the enabled configuration is valid by performing the same tests as cfgEnable.
If the tests fail, an error is displayed and the configuration is not saved. Tests may fail if a
configuration has been modified since the last cfgEnable.
Note:
Operands None.
Example To enable a zone configuration, then save it:
See Also
cfgClear
cfgDisable
cfgEnable
cfgShow
Fabric OS Reference
This command requires a Zoning License.
switch:admin> cfgEnable "Test_cfg"
zone config "Test_cfg" is in effect
switch:admin> cfgSave
Updating flash...
1
Telnet Commands
1-25