Diagclearerror - HP StorageWorks 8B - FC Entry Switch Reference Manual

1
Telnet Commands

diagClearError

Clear the diag software flag to allow for retest.
Synopsis
diagClearError [port]
Availability
admin
Description
Use this command to clear the diagnostic software flag that indicates whether a port is BAD or OK.
The current flag settings are displayed by using the diagShow command. This command resets the
flag to allow the bad port to be retested; otherwise the test skips the port.
This command does not clear the error log entry. Instead, it generates the following
DIAG-CLEAR_ERR message for each port software flag cleared. For example, the following
message is for a diagnostic error cleared from port 3:
0x10f9d560 (tShell): Apr
Error DIAG-CLEAR_ERR, 3,
Pt13 (Lm3) Diagnostics Error Cleared
Err# 0001
Operands
This command has the following operand:
port
If no operand is specified, the default is to clear all bad port flags.
Example To clear the diag software flag:
See Also
diagShow
1-52
Specify the port where you want to reset the diagnostic software flag. Valid
values for port number vary depending on the switch type. This operand is
optional.
switch:admin> diagClearError
0x10f9d5e0 (tShell): Apr
Error DIAG-CLEAR_ERR, 3,
Pt7 (Lm1) Diagnostics Error Cleared
Err# 0001
9 08:35:50
6 13:25:36
Fabric OS Reference