Qlpartner - HP StorageWorks 8B - FC Entry Switch Reference Manual

qlPartner

Sets QuickLoop partner or displays information about partner.
Synopsis
qlPartner [0|wwn]
Availability
admin
Description
Use this command to set the QuickLoop to single/dual switch mode or to display the QuickLoop
scope setting.
If no argument is specified, this command displays the current QuickLoop mode, which can be
single or dual switch. If in dual switch mode, the partner's WWN also displays.
If 0 is used as argument, this command sets the QuickLoop to run in single switch mode, and
restarts the switch if this causes a change in mode.
If a non-zero and valid WWN (a WWN that is part of the fabric) for a switch is specified, that
switch becomes the QuickLoop partner. The switch is then restarted to run in dual switch mode.
The partner setting is updated in flash memory.
Note:
Operands
This command has the following operand:
[0 | wwn]
If no operand is specified the current value is displayed.
Example The following entry sets another switch as a QuickLoop partner switch:
See Also
configShow
qlShow
Fabric OS Reference
If Zoning is in use the qlDisable, qlEnable, and qlPartner commands are not in effect. In
this case, dual switch QuickLoops can be managed using the telnet commands available
through Zoning.
Specify 0 to set the QuickLoop to run on single switch. Specify a WWN to set
the QuickLoop to run on dual switches. This operand is optional.
switch:admin> qlPartner "10:00:00:60:69:10:10:ec"
1
Telnet Commands
1-211