HP StorageWorks 8B - FC Entry Switch Reference Manual page 59

Portlog Events Enable
Use these parameters to specify which events create an entry in the port log. The Portlog Events
fields are as follows:
Table 1-5
Field
start: a switch start or re-start event
disable: a port is disabled
enable: a port is enabled
ioctl: a port I/O control is executed
Tx: a frame is transmitted
Tx1: a frame is transmitted, class 1
Tx2: a frame is transmitted, class 2
Tx3: a frame is transmitted, class 3
Rx: a frame is received
Rx1: a frame is received, class 1
Rx2: a frame is received, class 2
Rx3: a frame is received, class 3
stats: port status or statistics
scn: a state change notification
pstate: a port changes physical state
reject: a received frame is rejected
busy: a received frame is busied
ctin: a CT based request is received
ctout: a CT based response is transmitted
errlog: a message is added to the error log
loopscn: a loop state change notification
create: a task is created
debug: generic debug info
nbrfsm: neighbor state transition
timer: timer
sn: speed negotiation
Operands None.
Fabric OS Reference
Configure Command Portlog Events parameters
Telnet Commands
(Valid Values) Default Value
(on, off): [on]
(on, off): [on]
(on, off): [on]
(on, off): [on]
(on, off): [on]
(on, off): [on]
(on, off): [on]
(on, off): [on]
(on, off): [on]
(on, off): [on]
(on, off): [on]
(on, off): [on]
(on, off): [on]
(on, off): [on]
(on, off): [on]
(on, off): [on]
(on, off): [on]
(on, off): [on]
(on, off): [on]
(on, off): [on]
(on, off): [on]
(on, off): [on]
(on, off): [on]
(on, off): [on]
(on, off): [on]
(on, off): [on]
1
1-45