Part Code 4010 - HP StorageWorks P9000 Manual

Part code 4010

Table 40 Error codes (part code 4010)
Part Error
Code Number
4010 1030
4010 1032
4010 2080
4010 5010
4010 501 1
4010 5030
4010 5058
4010 7440
4010 9000
4010 9010
4010 9060
4010 9340
4010 59035
4010 65643
Error Message
Part of the range is already in use.
The specified value is outside the valid
range.
Prestaging not completed.
The value specified as the ending
address for the data to be placed in
cache is smaller than the value specified
as the starting address.
The value specified as the Number of
Cache Residency areas is equal to or
less than one cylinder.
No deletion area is specified. Retry the
operation to specify the deletion area.
The Cache Residency settings that
exceed the maximum size or maximum
available area are invalid.
An error occurred during processing. If
this problem persists please contact HP
Technical Support.
Prestaging has completed.
This setting will take effect.
Do you want to delete?
Are you sure you want to reset the
information?
Prestaging will be carried out to the
selected LDEV. Do you want to continue?
The number of Extents in the LDEV has
exceeded the maximum.
Recommended Action
Correct the specified content, and issue
the request again.
Correct the specified content, and issue
the request again.
Wait, click [Refresh], and change the
same configuration again. Check the
DKC status. If the same error occurs,
please contact HP Technical Support.
Correct the values specified as the
starting and ending addresses, then retry
the operation.
Correct the specified content, and retry.
Correct the specified content, and retry.
Correct the Cache Residency settings,
then retry the operation.
An error occurred. If this problem
persists, please contact HP Technical
Support.
The normal end was carried out. Click
[OK] and close the dialog.
-
-
The information of the program product
will be reset if you click [OK]. The
information will not be reset if you click
[Cancel].
To perform the prestaging operation,
click [Yes]. To not perform the prestaging
operation, click [No].
Reduce the number of Extents in the
LDEV.
Severity
Level
i
i
E
W
W
W
W
E
i
i
i
W
i
E
Part code 4010 1 13