HP StorageWorks P9000 Manual page 316

Table 92 Error codes (part code 20122) (continued)
Part Error
Code Number
20122 105065
20122 105066
20122 105068
20122 105069
20122 105278
20122 106004
20122 106039
20122 106056
20122 106057
20122 106058
20122 106059
20122 106060
20122 106061
20122 106072
20122 106073
20122 106074
20122 106075
316 Message (part code group 20nnn)
Error Message
The task cannot be aborted.
This task cannot be aborted.
The auto delete has already been set to
disable.
The auto delete has already been set to
enable.
This operation has a possibility to cause
conflict of setting items with the task of
"In progress" or "Not run." Note the
conflict of set items. Do you want to
continue?
An unexpected error occurred.
An error occurred.
An error occurred.
An error occurred.
An error occurred.
An error occurred.
An error occurred.
An error occurred.
The tree node cannot be expanded any
further.
Only a host registered in a group is
allowed to access a LUN that is defined
in the target group. A host that is not
registered in any group is not allowed
to access any LUN. Do you want to
continue this operation?
All the hosts connected to the target ports
are only allowed to access a LUN that
is defined in the group #00. This will
lead the possibility that LUNs, which are
defined in the group other than #00
being used at present, cannot be
recognized, then the file system might
be destroyed. Do you want to continue
this operation?
The configuration does not become
effective until the security switch is turned
on.
Recommended Action
The status of the task might be changed.
Close the window, then check the task
status.
Check the setting(s).
Check the setting(s).
Check the setting(s).
To continue the processing, click [OK].
Otherwise, click [Cancel].
If the same problem persists despite
retrying, please contact HP Technical
Support.
Confirm the details of the error from the
following error code list.
Check the details of the error from the
following error code list.
Check the details of the error from the
following error code list.
Check the details of the error from the
following error code list.
Check the details of the error from the
following error code list.
Check the details of the error from the
following error code list.
Check the details of the error from the
following error code list.
Collapse other tree nodes, then retry the
operation.
To continue processing, click [OK]. To
stop processing, click [Cancel].
To continue processing, click [OK]. To
stop processing, click [Cancel].
Turn the security switch on.
Severity
Level
W
W
W
W
W
E
E
E
E
E
E
E
E
W
W
W
W