HP StorageWorks P9000 Manual page 257

Table 62 Error codes (part code 7105) (continued)
Part Error Error Message
Code Number
7105 8580 The specified volume is for backup
servers only.
7105 8581 The specified volume is not for backup
servers only.
7105 8582 The emulation type of the target volume
is being changed.
7105 8583 The RAID level of the specified volume
is not supported.
7105 8584 No volume is defined as a reserved
volume.
7105 8585 The number of reserved volumes exceeds
the maximum.
7105 8586 The number of groups that can be set in
the same subsystem is invalid.
7105 8587 The number of pairs that can be set in
the same group is invalid.
7105 8588 The specified group number is not set.
7105 8589 The specified group name is invalid.
7105 8590 The group name and the number do not
match.
7105 8591 The specified pair is already set in
another group.
7105 8592 The command was rejected because the
licensed capacity was exceeded.
7105 8593 The S-VOL is a source volume for Auto
LUN.
7105 8594 The S-VOL is a target volume for Auto
LUN.
7105 8595 The specified S-VOL does not exist.
7105 8596 The specified volume is a reserved
volume.
7105 8597 The command has been rejected,
because the number of pairs created with
the specified S-VOL has reached the
maximum.
7105 8598 The specified volume is not an S-VOL.
7105 8599 The specified volume is already an
S-VOL.
Recommended Action
You cannot use the volume. Specify other
volume, and retry the operation.
Check the contents, and retry.
Wait a while, and retry the operation.
Specify the volume of the supported RAID
level.
Define the reserve volume, then retry the
operation.
Stop the operation of the Reserve volume
setting, or delete the Reserve volume.
Check the contents, and retry.
Check the contents, and retry.
Check the contents, and retry.
Check the contents, and retry.
Check the contents, and retry.
Check the contents, and retry.
Check the capacity of the installed
license key. To create more pairs,
purchase a license key for larger
capacity.
Release the Auto LUN setting.
Release the Auto LUN setting.
Refresh, then retry the operation.
Check the status of the volume.
Pairs cannot be created with the
specified S-VOL any more.
See the section "Volume pairs (S-VOLs
and T-VOLs)" in the HP StorageWorks
P9000 Business Copy for Mainframe
Systems User Guide for the composition
of pairs.
Check the status of the volume.
Specify other P-VOL, and retry the
operation. Or delete the pair of the
specified volume, then retry the
operation.
Severity
Level
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
Part code 7105 257