HP StorageWorks P9000 Manual page 132

Table 46 Error codes (part code 5205) (continued)
Part Error
Code Number
5205 65715
5205 65716
5205 65737
5205 65738
5205 65739
5205 65740
5205 65748
5205 65749
5205 65750
5205 65784
5205 65785
5205 65786
5205 75008
5205 75010
132 Message (part code group 5nnn)
Error Message
Migration cannot be executed because
it is a migration between a Thin
Provisioning volume and a normal
volume that contains a component of a
LUSE volume
The specified volume cannot be set as a
reserved volume.
The specified volume cannot be used,
because it is a volume of Thin
Provisioning whose capacity is being
added.
The volume specified as a migration
target cannot be used, because it is a
volume of Thin Provisioning in capacity
expanding.
The specified volume cannot be used,
because it is a volume of Thin
Provisioning whose capacity is being
added.
The configuration changing processes
are conflicting at DKC.
The volume specified as a migration
source cannot be used, because it is a
volume of Thin Provisioning in zero data
discarding.
The volume specified as a migration
target cannot be used, because it is a
volume of Thin Provisioning in zero data
discarding.
The specified volume cannot be used,
because it is a volume of Thin
Provisioning whose zero data is being
discarded.
The volume specified as a migration
source cannot be used, because it is a
quorum disk.
The volume specified as a migration
target cannot be used, because it is a
quorum disk.
The volume specified as the reserved
volume cannot be used, because it is a
quorum disk.
The volume specified as a reserved
volume has an LU path setting.
The number of target volumes that can
be executed at once exceeds the
maximum.
Recommended Action
Check the setting of the specified volume.
Check the setting of the specified volume.
Check the specified volume capacity
after the completion of the capacity
expanding operation.
Confirm the capacity of the volume
specified as a migration target after the
capacity expanding operation is
completed.
Check the specified volume capacity
after the completion of the capacity
expanding operation.
Check if the configuration changing
process by RAID Manager, Auto LUN,
or Quick Restore is not in the operation,
then retry the operation.
Retry the operation after the zero data
discarding operation is completed.
Retry the operation after the zero data
discarding operation is completed.
Retry the operation after the zero data
discarding operation is completed.
Check the content of the operation.
Check the content of the operation.
Check the content of the operation.
Specify another volume, then retry the
operation.
Correct the number of reserved volumes
to set or release to 64 or less, and the
number of manual migration instructions
to 8 or less, then retry the operation.
Severity
Level
W
W
W
W
W
W
W
W
W
W
W
W
W
W