HP StorageWorks P9000 Manual page 59

Table 25 Error codes (part code 1005) (continued)
Part Error Error Message
Code Number
1005 1356 You could not add the host group to the
initiator or external port.
1005 1357 S-VOLs remain on the Fibre-RCU port.
This operation may cause a fatal
damage to the S-VOLs. Please stop this
operation. If you want to continue this
operation, please remove the S-VOLs
from the RCU port first.
1005 1361 No more user LUs can be set, because
the number of user LU settings has
reached the maximum.
1005 1363 You cannot add paths to journal
volumes.
1005 1364 The port type is incorrect.
1005 1367 The host mode "4C" is used for a host
group connecting to volumes that cannot
be used for External Storage.
1005 1368 The host mode "4C" can only be used
with External Storage volumes.
1005 1600 This functionality is not available. Open
System Array Management is required.
1005 1601 This functionality is not available. Open
System Array Management is required.
1005 1904 The specified volume cannot be assigned
as an LUSE volume or a command
device, and the path of the volume
cannot be set because it is being used
as a Pool volume.
1005 1906 The specified volume cannot be set as a
command device because it is being
used as a V-VOL for Snapshot.
1005 1912 The specified volume is a remote
command device, and therefore the
command device setting or the command
device security setting cannot be set or
released.
1005 1918 An external volume is mapped to the
external port to be operated.
1005 1926 The path cannot be set to the specified
volume, because the volume is being
used as a quorum disk.
1005 1927 The specified volume cannot be set as a
command device, because it is being
used as a quorum disk.
1005 2005 An error occurred during SVP
processing.
Recommended Action
To add the host group, change the
attribute of the specified port to Target
or RCU Target.
The specified port is for Fibre Continuous
Access Synchronous. Delete a logical
path, then retry the operation.
Reduce the number of user LU settings,
then retry the operation.
Correct the settings, then retry the
operation.
Check the port type, then retry the
operation.
Check the settings, then retry.
Check the settings, then retry.
Install the necessary license key.
Install the necessary license key.
Select another volume.
Select another volume.
Correct the settings, then retry the
operation.
Delete the external volume that is
mapped to the external port to be
operated, then retry the operation.
Check the setting.
Check the setting.
If this problem persists, please contact
HP Technical Support.
Severity
Level
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
Part code 1005 59