HP StorageWorks P9000 Manual page 274

Table 65 Error codes (part code 8105) (continued)
Part Error
Code Number
8105 1066
8105 1067
8105 1068
8105 1 108
8105 1 1 10
8105 1 1 1 1
8105 1 1 16
8105 1 123
8105 1 124
274 Message (part code group 8nnn)
Error Message
WWN number, which is not registered,
is specified. (When deleting, or
changing.)
You are trying to register the same host
group as the existing one.
The specified host group has not been
registered.
The following volumes cannot be
specified when you change the
command device configurations:
Volumes reserved by Auto LUN
Volumes other than the open-system
volumes (including unmounted
volumes)
System Disk volume
You cannot use following characters for
the name:
" \ / : , ; * ? < > |
You cannot use spaces for the first and
the last characters in the name.
When requesting a configuration change
of LUN-Security, a nickname is not
specified. Specify the nickname of HOST
GROUP.
When registering WWN, the value is
not specified. Or, zero is set as the value
of WWN. Be sure to set the WWN
value before requesting the configuration
change.
Command device security cannot be set
to the specified volume because the
volume is not a command device.
An error occurred. If this problem
persists, please contact HP Technical
Support.
The command device setting and the
command device security setting are
incorrect. You cannot do any of the
following to the same volume:
Specify the volume as a command
device and disable command device
security on the volume.
Specify the volume as a
non-command device and enable
command device security on the
volume.
Recommended Action
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
Check the setting, then retry the
operation.
Remove the prohibited characters from
the nickname.
Check the setting(s), then retry the
operation.
Check the setting(s), then retry the
operation.
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
The setting method of command
device/command device security is
incorrect. The following settings are
invalid. *Set command device + Release
command device security
*Release command device + Set
command device security
The error does not occur normally
because it cannot be modified in the
window. In the unlikely event that this
error occurs, please contact HP Technical
Support.
Severity
Level
W
W
W
W
W
W
W
W
W