HP StorageWorks P9000 Manual page 275

Table 65 Error codes (part code 8105) (continued)
Part Error Error Message
Code Number
8105 1 125 There are no host groups where the
WWN will be registered.
8105 1 128 An error occurred. If this problem
persists, please contact HP Technical
Support.
8105 1 130 The specified name is the same as the
system default name. Please change the
name.
8105 1 131 Failed to set the host group because the
number of host groups exceeds the
maximum that can be set in a port.
8105 1 132 Failed to set the WWN because the
number of WWNs exceeds the
maximum that can be set in a port.
8105 1 133 Failed to set the host mode because the
number of host modes exceeds the
maximum that can be set in a port.
8105 1 134 Failed to set the path because the
number of paths exceeds the maximum
that can be set in a port.
8105 1 135 When setting the port information (Fibre
Address/Fibre Topology/Channel
Speed), multiple change instructions are
set to the same port.
8105 1 138 The same setting is specified at LUNM
operation
8105 1 140 Because the Port Group setting is done,
it is impossible to change.
8105 1 170 The volume cannot be configured as a
command device because the volume
does not have Read/Write attribute.
8105 1 181 The specified path cannot be added,
because the volume is used by a Remote
Copy pair.
8105 1 193 You cannot add paths to Remote Copy
or Business Copy pair volumes.
8105 1350 Add path to the initiator port failed.
Recommended Action
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
Check the setting(s), then retry the
operation.
Correct the specified contents, and
request again.
The configuration information has been
already changed.
Check the settings, and request the
setting of the configuration information
again.
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
Check the setting(s), then retry the
operation.
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again
Release the Port Group setting.
Connect settings, then retry.
Correct the specified contents, and
request again.
Correct the settings, then retry.
The port you are trying to set is for
Remote Copy. You must change the
attribute (Target or RCU Target) when
adding a path.
Severity
Level
W
W
W
W
W
W
W
W
W
W
W
W
W
W
Part code 8105 275