HP StorageWorks P9000 Manual page 225

Table 56 Error codes (part code 6610) (continued)
Part Error Error Message
Code Number
6610 9332 This operation is not applied yet.
6610 55036 Too many data volumes in the journal.
6610 55037 Too many mirrors in the journal.
6610 55038 Too many mirrors in the subsystem.
6610 55039 You are specifying "Mirror" for the range
and trying to manipulate the same
mirror. Select only one data volume pair
in the mirror when you specify "Mirror"
for the range.
6610 55202 The specified controller ID cannot be
used.
6610 55207 Some of the specified values are
incorrect. Two times the value of "M-JNL
Cache" plus the value of "R-JNL Cache"
must be equal to or less than 100. Or,
the value of "Threshold of start Async
JNL" must be equal to or less than the
value of "Threshold of start Sync JNL."
6610 55208 The specified journal number is incorrect.
Specify the correct journal number.
6610 55229 There are some pairs where "Mirror" is
not specified as the range in the pairs
specified to be deleted forcibly.
Specify "Mirror" as the range when you
want to delete pairs forcibly.
6610 55644 [Warning]
There are some pairs where "Group" is
not specified as the range in the pairs
specified to be deleted forcibly.
Other pairs in the same group may
suspend due to a failure by this
operation.
Are you sure you want to delete pairs?
6610 56504 There is no journal registered that has
the same CLPR number as the specified
volume.
Register a journal that has the same CLPR
number as the specified volume, then
retry the operation.
6610 56505 There are no secondary subsystems
available. Please register secondary
subsystems and then retry the operation.
Recommended Action
Click [OK], then continue the operation.
Check the number of data volumes in the
journal. Then delete unused data volume
pairs, or register them in another journal.
Check the number of mirrors in the
journal. Then delete unused mirrors, or
register them in another journal.
Check the number of mirrors in the
journal group, then delete unused
mirrors.
Check the range setting. If you specify
"Mirror," select only one data volume
pair in the mirror.
Check the specified controller ID.
The value of "Threshold of start Async
JNL" must equal or be less than the
"Threshold of start Sync JNL" value.
Specify the correct journal number.
Specify normal deletion, or specify
"Mirror" as the range.
To delete pairs, click [Yes]. Otherwise,
click [No].
Register a journal that has the same CLPR
number as the specified volume, then
retry the operation.
Register secondary storage systems, then
retry the operation.
Severity
Level
i
W
W
W
W
W
W
W
W
W
W
W
Part code 6610 225