HP StorageWorks P9000 Manual page 273

Table 65 Error codes (part code 8105) (continued)
Part Error Error Message
Code Number
8105 1007 Failed to remove the path. The specified
path is the last path of the volumes used
for Remote Copy, Business Copy, Auto
LUN, or Snapshot.
8105 1009 The emulation type of the volumes is not
for open systems, or the volumes are not
mounted.
8105 1010 An error occurred during SVP
processing.
8105 1018 The specified port does not exist. Or the
specified port type is not Fibre port.
8105 1022 Invalid host mode.
8105 1023 The specified fiber address is wrong.
8105 1024 Invalid Fibre topology information.
8105 1025 The specified LU path does not exist.
8105 1059 LUN security setting has been made to
a non-Fibre port. LUN security is a
function of LUN Manager.
8105 1061 Security Switch Off operation and path
adding operation cannot be performed
simultaneously.
8105 1063 The specified WWN is already in use.
8105 1064 You are trying to register the same
WWN that is already registered.
8105 1065 The specified host name or the host
group name is already registered. (The
host name and the host group name
cannot be the same.)
Recommended Action
Check the setting.
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
If this problem persists, please contact
HP Technical Support.
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
Correct the specified content, and issue
the request again. (Currently, Bad Value
Send report in Set Response.)
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again
Check the specified contents, then retry
the operation.
You are trying to perform LUN Security
operation for a port where LUN Security
function is invalid. The error does not
occur normally because it cannot be
modified in the window. In the unlikely
event that this error occurs, please
contact HP Technical Support.
Check the specified contents, then retry
the operation.
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
Correct the specified contents, and
request the setting of the configuration
information again.
Severity
Level
W
W
W
W
W
W
W
W
W
W
W
W
W
Part code 8105 273