HP StorageWorks P9000 Manual page 142

Table 50 Error codes (part code 6005) (continued)
Part Error
Code Number
6005 8723
6005 8724
6005 8725
6005 8727
6005 8728
6005 8729
6005 8730
6005 8731
6005 8732
6005 8733
6005 8734
142 Message (part code group 6nnn)
Error Message
The Edit Path operation was rejected
because the specified path is the last
path of some Remote Copy pairs.
Specified number of paths is less than
the minimum specified on RCU Option
screen.
Current microcode version does not
support the specified operation.
The number of minimum paths exceeds
the number of normal paths.
The number of minimum paths exceeds
the number of normal paths.
An internal error occurred.
Invalid Logical Addresses are specified.
The existing logical addresses are not
equal.
Too many SSIDs (only Four SSIDs are
allowed).
The Fibre-Remote Copy function is not
installed in the specified MCU.
The Fibre-Remote Copy function is not
installed in the specified RCU.
Recommended Action
Add another path, or delete
all pairs on the RCU. Then
retry the operation.
The specified number of
paths is less than the
minimum number of paths
specified on the RCU Option
window.
The version of the microcode
on the XP512/XP48 Disk
Array does not support the
specified function or
operation. Please contact HP
Technical Support.
Add the normal path(s), then
set the minimum number of
paths.
Please take either of the
following actions:
Add normal paths, then
delete the paths.
Decrease the number of
minimum paths, then delete
the paths.
Please contact HP Technical
Support.
If you are adding RCUs,
specify the same logical
address.
If you are editing paths,
specify the same logical
address as the existing
paths. (See the Edit Path
dialog box.)
The logical addresses of all
existing paths are not the
same. Delete the RCU, then
re-add it, using the same
logical address as other
existing paths.
The maximum number of
SSIDs (four) has been
entered. Verify that the SSIDs
are valid, delete one or
more, then retry the
operation.
Install the program product
key in the MCU.
Install the program product
key in the RCU.
Severity Level
W
W
W
W
W
E
W
W
W
W
W