HP StorageWorks P9000 Manual page 234

Table 59 Error codes (part code 7005) (continued)
Part Error
Code Number
7005 8501
7005 8502
7005 8503
7005 8504
7005 8505
7005 8506
7005 8507
7005 8508
7005 8509
7005 8510
7005 851 1
7005 8512
7005 8513
7005 8514
7005 8515
7005 8516
234 Message (part code group 7nnn)
Error Message
The command has been rejected,
because the command specified last time
is being processed.
You cannot reserve the volume, because
a remote copy pair exists in the same
subsystem frame.
You cannot create the new pair, because
a remote copy pair exists in the same
subsystem frame.
The command was rejected. Check the
composition, the status, or the volume
status of the pair.
The command has been rejected,
because the operation cannot be
accepted in the current pair status.
The command has been rejected,
because the specified S-VOL or reserved
volume is used by the host.
The Pairsplit command was issued to the
pairs in a PSUS status.
The Paircreate command was issued to
the pairs in a PSUS status.
The Split command with the QUIESCE
specification was issued to a secondary
boot device.
The M-VOL Suspend command was
issued to a secondary boot device.
You cannot reserve the volume, because
a path group is set.
Cannot perform Pairresync or Pairsplit-E
operation because of the path group
setting.
The command has been rejected,
because the specified P-VOL is used by
the host.
No reserved volume can be allocated.
The number of cylinders in the reserved
volume exceeds the maximum.
The number of P-VOL cylinders exceeds
the maximum.
Recommended Action
Wait a while, and retry the operation.
Delete the Remote Copy pair.
Delete the Remote Copy pair.
Confirm the composition, the status, or
the volume status of the pair. (See the
HP StorageWorks P9000 Business Copy
User Guide for the relation between the
composition of the pair, status of the
pair, or the volume status of the pair and
those operations.)
See the section "Operations permitted
for L1, L2 pairs" in the HP StorageWorks
P9000 Business Copy User Guide for
the relation between the status of pairs
and the commands that can be
accepted.
Vary the S-VOL or the reserved volume
offline from the mainframe host, then
issue the command again.
You cannot execute the Pairsplit
command because the pair is already in
the PSUS status.
You cannot execute the Pairsplit
command because the pair is already in
the PSUS status.
Check the contents, and retry.
Check the contents, and retry.
Detach the S-VOL from the host, or delete
the Remote Copy path.
Detach the S-VOL from the host, or delete
the Remote Copy path.
Vary the P-VOL offline from the
mainframe host, then issue the command
again.
Delete the Reserve volume.
Check the contents, and retry.
Check the contents, and retry.
Severity
Level
W
W
W
W
E
W
W
W
W
W
W
W
W
W
W
W