HP StorageWorks P9000 Manual page 60

Table 25 Error codes (part code 1005) (continued)
Part Error
Code Number
1005 2009
1005 2010
1005 2013
1005 2015
1005 2032
1005 2082
1005 2083
1005 2084
1005 2097
1005 2098
1005 2099
1005 2100
1005 2501
1005 2504
1005 3002
1005 3003
1005 3006
1005 3007
60 Message (part code group 1nnn)
Error Message
An error occurred during SVP
processing.
The LDEV is being used by the host, or
an error occurred in the SVP procedure.
An error occurred during SVP
processing.
An error occurred while connecting to
the storage system.
An error occurred while connecting to
the storage system.
Processing is disabled because the host
is mounted or the device is reserved.
The subsystem status is invalid.
The subsystem status is invalid.
The host specified by the WWN is
performing I/O operations.
The operation cannot be performed,
because the SVP microcode version does
not match the DKCMAIN (subsystem)
microcode version.
The operation cannot be performed,
because an inoperative Processor exists.
An error occurred while connecting to
the storage system. The configuration
may be inconsistent.
The volume cannot be configured as a
command device because the volume
does not have Read/Write attribute.
No settings can be made because of a
volume reserved for RAID Manager.
An error occurred during SVP
processing.
An error occurred during SVP
processing.
An error occurred during SVP
processing.
An error occurred during SVP
processing.
Recommended Action
If this problem persists, please contact
HP Technical Support.
Recovery processing may take about 1
minute. Wait for a while.
If this problem persists, please contact
HP Technical Support.
If the same error occurs despite retrying,
please contact HP Technical Support.
If the same error occurs despite retrying,
please contact HP Technical Support.
Unmount the host and cancel reservation
of the device. If the host is an AIX host,
unmount the host, and execute the
varyoffvg command.
Check the DKC status and the current
status of the configuration setting. If
necessary, re-execute the setting
operation.
Check the DKC status and the current
status of the configuration setting. If
necessary, re-execute the setting
operation.
Check the settings, then retry the
operation.
When the same problem persists, please
contact HP Technical Support.
Wait a while, then retry the operation.
If the same problem persists. Please
contact HP Technical Support.
Click [Refresh All] on the [File] menu,
then refresh the configuration. If the same
problem persists despite retrying, please
contact HP Technical Support.
Correct the settings, then retry.
Release the reserved attribute of the
target volume by using Data Retention.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
Severity
Level
E
W
W
W
W
W
W
W
W
E
W
W
W
W
E
E
E
E