HP StorageWorks P9000 Manual page 303

Table 85 Error codes (part code 9605) (continued)
Part Error Error Message
Code Number
9605 7310 This error code is not registered.
9605 8001 An error occurred while connecting to
the subsystem. Please retry a little later.
9605 8002 A communication time-out error occurred
in the subsystem. Please wait for a while,
and then retry the operation.
9605 8102 This function is not supported.
9605 8120 The specified logical volume does not
exist.
9605 8122 This logical volume is busy.
9605 8123 This function is not supported.
9605 8124 This logical volume is a mainframe
volume.
9605 8125 The attribute of the logical volume has
been changed by RAID Manager.
9605 8126 This logical volume is configured as a
command device.
9605 8128 A parameter error occurred.
9605 8132 This error code is not registered.
9605 8134 The attribute of this logical volume
cannot be changed to Read/Write.
9605 8135 This logical volume is already used as
an S-VOL for Remote Copy or Business
Copy.
9605 8136 The command was rejected, because the
licensed capacity was exceeded.
9605 8138 The Reserved setting of the specified
volume cannot be released.
9605 8139 The specified volume is a P-VOL for
Business Copy.
9605 8141 This logical volume cannot be selected
because it is used as a reserve volume
for Auto LUN.
9605 8142 You cannot select this logical volume
because it is used as a Continuous
Access Journal volume.
9605 8150 You tried to set a retention term to a
logical volume whose access attribute is
not Read Only or Protect.
9605 8151 The retention term of the logical volume
cannot be shortened.
Recommended Action
If this problem persists, please contact
HP Technical Support.
Retry a little later.
Retry a little later.
Check if the DKCMAIN and SVP
microcode versions are mismatched.
Specify an open-system volume.
Retry a little later.
Check if the DKCMAIN and SVP
microcode versions are mismatched.
Specify an open-system volume.
Review LDEV information, then retry.
Check the logical volume configuration,
then retry the operation.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
To change the attribute, please contact
HP Technical Support.
Check the logical volume configuration,
then retry the operation.
The currently licensed capacity is
insufficient. To increase the licensed
capacity, buy a new license key.
To release the Reserved setting, please
contact HP Technical Support.
Check the volume, then retry the
operation.
Check the volume, then retry the
operation.
Check the logical volume, then retry the
operation.
Check the logical volume, then retry the
operation.
To shorten it, please contact HP
Technical Support.
Severity
Level
E
W
W
E
W
W
E
W
W
W
E
E
E
W
W
E
W
W
W
W
W
Part code 9605 303