HP StorageWorks P9000 Manual page 236

Table 59 Error codes (part code 7005) (continued)
Part Error
Code Number
7005 8537
7005 8538
7005 8539
7005 8540
7005 8541
7005 8542
7005 8543
7005 8544
7005 8545
7005 8546
7005 8547
7005 8548
7005 8549
7005 8550
7005 8551
7005 8552
7005 8553
7005 8554
7005 8555
7005 8556
7005 8557
236 Message (part code group 7nnn)
Error Message
The cache capacities do not match.
An SM failure was detected.
There is insufficient shared memory to
create 4096 pairs.
There is sufficient shared memory to
create 4096 pairs, but initial subsystem
setup is required before creating pairs.
There is sufficient shared memory to
create 4096 pairs, and the initial
subsystem setup is complete.
Failed to complete the initial shared
memory setup.
The shared memory size is different.
16 Mbytes of shared memory is
available.
A power supply failure is detected.
The command was rejected. The PS OFF
is in progress.
A data transfer failure is detected (CHA).
A data transfer failure is detected (DKA).
The P-VOL is not implemented.
The command has been rejected,
because the specified P-VOL is blocked
or used as a system disk.
The P-VOL is being formatted.
This volume cannot be specified as an
P-VOL because it is used as a command
device.
The S-VOL is not implemented.
The command has been rejected,
because the specified S-VOL is blocked
or used as a system disk.
The S-VOL is being formatted.
This volume cannot be specified as an
S-VOL because it is used as a command
device.
The volume is not implemented.
Recommended Action
Please contact HP Technical Support.
Please contact HP Technical Support.
There is insufficient shared memory in
DKC. Please contact HP Technical
Support.
Please contact HP Technical Support.
Close the message box.
Please contact HP Technical Support.
Please contact HP Technical Support.
-
Please contact HP Technical Support.
Retry the operation with power ON.
Please contact HP Technical Support.
Please contact HP Technical Support.
You cannot execute the operation for the
volume which is not implemented.
Restore the blocked volume, then retry
the operation.
The system disk cannot be specified
as a P-VOL. Specify another volume.
Wait until the volume is formatted, and
retry the operation.
Check the target volume.
You cannot execute the operation for the
volume which is not implemented.
Restore the blocked volume, then retry
the operation.
The system disk cannot be specified
as an S-VOL. Specify another volume.
Wait until the volume is formatted, and
retry the operation.
A volume that is not used as a command
device must be specified as an S-VOL.
You cannot execute the operation for the
volume which is not implemented.
Severity
Level
E
E
E
E
i
E
E
i
E
W
E
E
W
E
W
W
W
W
W
W
W