Part Code 71 10 267 - HP StorageWorks P9000 Manual

Part code 71 10
Table 63 Error codes (part code 71 10)
Part Error
Code Number
71 10 51 15
71 10 51 16
71 10 51 19
71 10 5120
71 10 5121
71 10 5122
71 10 5123
71 10 5124
71 10 5125
71 10 6504
71 10 7310
71 10 731 1
71 10 7312
71 10 7313
71 10 7440
71 10 8001
71 10 8534
71 10 8568
71 10 8658
71 10 8659
71 10 9002
Error Message
The T-VOL size differs from the specified
source volume size.
You cannot create another pair, because
the number of pairs exceeds the
maximum.
The S-VOL is not selected.
The T-VOL is not selected.
The data has been changed. If you select
another tab (page), the settings will be
discarded. Are you sure you want to
continue?
No data has been changed.
The password is invalid.
You cannot select more than one
operation at a time.
No target volume is selected.
The number of pairs exceeds the
maximum.
Unregistered error code.
The settings could not be applied.
The password could not be acquired.
Error details not available.
An error occurred during SVP
processing.
If this problem persists, please contact
HP Technical Support.
A time-out error occurred. Please wait
for the subsystem to recover to the
normal condition, and then retry the
operation.
An internal logic contradiction occurred.
The emulation type is invalid.
Some settings could not be applied
normally. Refer to the error code.
There is no volume.
The requested operation has completed.
Recommended Action
Check the capacity of S-VOL and T-VOL.
Specify a volume with the same capacity,
and retry the operation.
You cannot create the specified pair.
Delete the created pair, then retry the
operation.
Select the S-VOL, and retry the
operation.
Select the T-VOL, and retry the operation.
Apply the data in the Preview list. To
stop the transaction, click [OK] and
continue the operation.
Go on to the next operation.
Check the password.
Multiple volumes cannot be processed
in the operation. Process one volume at
a time.
Select the target volume.
You cannot create a pair for the
specified S-VOL. Delete the created pair,
and retry the operation.
Please contact HP Technical Support.
Wait a while, and retry the operation.
If the same error occurs despite retrying,
please contact HP Technical Support.
Please contact HP Technical Support.
Please contact HP Technical Support.
If this problem persists, please contact
HP Technical Support.
Retry the operation. If you get the same
message again, reboot the PC. If
necessary, please contact HP Technical
Support.
Please contact HP Technical Support.
Specify the volume of the supported
emulation type.
Check the error code in Preview list.
Check the contents, and retry.
The operation ended normally. Execute
the next operation.
Severity
Level
W
W
W
W
W
W
W
W
W
W
E
W
E
E
E
E
E
i
W
W
i

Part code 71 10 267