HP StorageWorks P9000 Manual page 178

Table 53 Error codes (part code 6505) (continued)
Part Error
Code Number
6505 8719
6505 8720
6505 8721
6505 8722
6505 8723
6505 8724
6505 8727
6505 8728
6505 8729
6505 8730
178 Message (part code group 6nnn)
Error Message
The serial number or the controller ID of
the remote subsystem is incorrect.
The number of registered remote
subsystems already reached the
maximum (that is, 64).
Path creation has not finished yet.
Path creation failed.
The Edit Path operation was rejected
because the specified path is the last
path of some Remote Copy pairs.
The specified number of paths is less
than the minimum number specified in
the DKC Option window.
The number of minimum paths exceeds
the number of normal paths.
The number of minimum paths exceeds
the number of normal paths.
An internal error occurred.
The specified logical address is incorrect.
Recommended Action
Check the serial number and the
controller ID of this remote storage
system and already registered remote
storage systems, then specify the correct
values.
If the specified values are correct, check
the cable connection of the remote
storage system. If the problem persists,
please contact HP Technical Support.
Reduce the number of registered remote
storage systems, then retry the operation.
Check the path connections between the
local and the remote storage systems,
then retry the operation.
Check the path connections between the
local and the remote storage systems,
then retry the operation.
Add another path, or delete all pairs on
the remote storage system. Then retry the
operation.
Check the number of paths.
Do either of the following to recover from
the error:
If the error code is 100c, add normal
paths, then set the minimum number
of paths.
If the error code is 100d, add normal
paths, then delete paths. Alternatively,
reduce the minimum number of paths,
then delete paths.
Do either of the following to recover from
the error:
If the error code is 100c, add normal
paths, then set the minimum number
of paths.
If the error code is 100d, add normal
paths, then delete paths. Alternatively,
reduce the minimum number of paths,
then delete paths.
Check the SSB log, then contact HP
Technical Support.
Do either of the following to recover from
the error:
If you are adding DKCs, specify the
same logical address.
If you are editing paths, specify the
same logical address as the existing
paths.
Severity
Level
W
W
W
W
W
W
W
W
E
W