HP StorageWorks P9000 Manual page 223

Table 56 Error codes (part code 6610) (continued)
Part Error Error Message
Code Number
6610 8101 The system cannot apply the new
configuration. Do you want to refresh?
6610 9006 Exchange the channel cable connections
after confirmation of the port type.
6610 9008 SIMs of Continuous Access Journal and
Continuous Access Journal Z are cleared.
6610 9009 The export is complete.
6610 9021 The Port Setting process has not
completed. Do you want to continue for
other ports?
6610 9024 Are you sure you want to exchange the
specified ports? Please confirm the
associated channel paths are off-line.
6610 9025 Are you sure you want to switch the
ports? If the remote copy paths exist on
the ports, delete them beforehand.
6610 9026 Are you sure you want to switch the
ports?
If any remote copy paths exist on the
ports, delete them beforehand.
Also, to avoid the switching operation
from being reported as a failure, confirm
first that a message prompting you to
change the channel cable connections
is displayed, and then perform the
necessary changes.
6610 9100 Do you want to exit?
6610 9101 Do you want to cancel?
6610 9102 Do you want to apply?
6610 9104 Do you want to change the mode?
6610 9105 The value that is under setup is not
reflected yet. Do you want to exit?
6610 9106 The value that is under setup is not
reflected yet. Do you want to change the
mode?
6610 9107 The value that is under setup is not
reflected yet. Do you want to continue
the operation?
6610 91 1 1 Do you want to delete the specified line
of settings from the Preview list?
6610 91 12 Do you want to continue this operation?
Recommended Action
Click [Refresh], and retry.
Check the port type, then change cable
connections.
Click [OK].
Click [OK].
To continue processing, click [Yes]. If the
processing finishes, reconfigure the port
that is not in operation.
Ensure that the associated channel paths
are offline.
Remove remote copy paths that are
associated with the ports.
To continue to change ports, click [OK].
To close the window, click [OK].
Otherwise, click [Cancel].
To cancel the operation, click [OK].
To apply settings in the Preview list to
the storage system, click [OK].
To apply settings in the Preview list to
the storage system, click [OK].
To discard the current settings and close
the window, click [OK]. Otherwise, click
[Cancel].
To discard the current settings and switch
to View mode, click [OK]. Otherwise,
click [Cancel].
To discard the current settings and
refresh the window, click [OK].
Otherwise, click [Cancel].
To discard the current settings, click
[OK]. Otherwise, click [Cancel].
To continue the current operation, click
[OK]. Otherwise, click [Cancel].
Severity
Level
W
i
i
i
i
i
i
W
i
i
i
i
W
W
W
W
i
Part code 6610 223