HP StorageWorks P9000 Manual page 121

Table 46 Error codes (part code 5205) (continued)
Part Error Error Message
Code Number
5205 1208 Auto LUN does not support the volume(s).
5205 1209 Auto LUN does not support the volume(s).
5205 1210 The shared memory to set a plan is
insufficient.
5205 121 1 The number of volume pairs exceeds the
maximum.
5205 1212 The source volume(s) is not equipped.
5205 1213 The command was rejected due to one
of the following reasons.
The volume specified as a migration
source was blocked.
The volume specified as a migration
source was used as a system disk.
5205 1214 The volume specified as a migration
source is being formatted.
5205 1215 The volume specified as a migration
source is a command device.
5205 1216 The target volume(s) is not equipped.
5205 1217 The command was rejected due to one
of the following reasons.
The volume specified as a migration
target was blocked.
The volume specified as a migration
target was used as a system disk.
5205 1218 The volume specified as a migration
target is being formatted.
5205 1219 The volume specified as a migration
target is a command device.
5205 1220 The volume is not a reserved volume.
Recommended Action
Retry the same operation. If nothing
changes, please contact HP Technical
Support.
Retry the same operation. If nothing
changes, please contact HP Technical
Support.
Install the shared memory if it is possible.
If it is impossible to install the shared
memory, the plan cannot be set any
further.
See the section about the computational
methods of the number of movement
plans described in the HP StorageWorks
P9000 Auto LUN User Guide for the
relation between the number of plans
that can be made and the shared
memory.
Retry the same operation. If nothing
changes, please contact HP Technical
Support.
Retry the same operation. If nothing
changes, please contact HP Technical
Support.
Recover the blocked volume, then retry
the operation. Also, the system disk
cannot be used as P-VOL. Specify
another volume.
Retry the operation after the format is
completed.
The command device cannot be used for
Auto LUN. Specify another volume.
Retry the same operation. If nothing
changes, please contact HP Technical
Support.
Recover the blocked volume, then retry
the operation. Also, the system disk
cannot be used as P-VOL. Specify
another volume.
Retry the operation after the format is
completed.
The command device cannot be used for
Auto LUN. Specify another volume.
Retry the same operation. If nothing
changes, please contact HP Technical
Support.
Severity
Level
W
W
W
W
W
W
W
W
W
W
W
W
W
Part code 5205 121