HP StorageWorks P9000 Manual page 186

Table 53 Error codes (part code 6505) (continued)
Part Error
Code Number
6505 58064
6505 58065
6505 58066
6505 58067
6505 58068
6505 58069
6505 58070
6505 58071
6505 58072
6505 58073
6505 58075
6505 58078
6505 58079
6505 58080
6505 58081
6505 58082
6505 58083
6505 58084
186 Message (part code group 6nnn)
Error Message
Too many requests. Please reduce the
number of requests to be processed at
one time. After that, please retry the
operation.
Invalid parameter (LDEV number).
Invalid parameter (Journal number).
Invalid parameter (Mirror ID).
Invalid parameter (Journal Control).
Invalid parameter (Suspend
Condition-Journal Full).
Invalid parameter (Suspend
Condition-Master Journal Failure).
Invalid parameter (Suspend
Condition-Restore Journal Failure).
The pair status has not changed yet.
Check the configuration of the
subsystems and the status of lines
connecting the subsystems, and then
check whether the status of the Remote
Copy pair is changed.
The subsystem is busy. Wait for a while,
and then retry the operation.
The specified serial number is incorrect.
The specified volume does not exist or
is unusable.
The specified primary data volume
cannot be used as an S-VOL (secondary
volume) because of Volume Retention
settings or Data Retention settings.
A Concurrent Copy operation is in
progress on the specified primary data
volume.
The specified primary data volume
belongs to an access group or a pool
group of Volume Security for Mainframe.
The specified consistency group is
already used.
The specified master journal is not
registered.
The specified primary data volumes
cannot be paired with another volume,
because the primary data volume is used
as a journal volume.
Recommended Action
Reduce the number of requests to be
processed at one time. Then retry the
operation.
Check the specified LDEV number.
Check the specified journal number.
Check the specified mirror ID.
Check the specified JNL Control
parameter.
Check the specified Suspend Condition
parameter.
Check the specified Suspend Condition
parameter.
Check the specified Suspend Condition
parameter.
The current configuration of the storage
systems and the current status of lines
connecting the storage systems may not
satisfy the operating conditions. Check
the configuration of the storage systems
and the status of lines connecting the
storage systems, then check whether the
status of the Remote Copy pair is
changed.
If the same error occurs despite retrying,
please contact HP Technical Support.
Check the specified serial number.
Check the status of the specified volume.
Check the status of the specified primary
data volume in the Volume Retention
window or the Data Retention window.
Check the status of the specified primary
data volume.
Check the status of the specified volume
in the Volume Security for Mainframe
window.
Check the consistency group status in the
Continuous Access Journal window of
the local and the remote storage systems.
Check the status of the specified master
journal.
Check the status of the specified primary
data volume.
Severity
Level
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W