HP StorageWorks P9000 Manual page 237

Table 59 Error codes (part code 7005) (continued)
Part Error Error Message
Code Number
7005 8558 The command has been rejected,
because the specified volume is blocked
or used as a system disk.
7005 8559 The volume is being formatted.
7005 8560 This volume cannot be specified because
it is used as a command device.
7005 8561 The command code is invalid.
7005 8562 The command code sender is invalid.
7005 8563 The volume type is invalid.
7005 8564 The volume type is invalid.
7005 8565 The command code sender is invalid.
7005 8566 The attribute of the reserved volume is
invalid.
7005 8567 The number of effective lists is invalid.
7005 8568 The emulation type is invalid.
7005 8569 The command has been rejected,
because the area of the differential table
or pair table to set pairs is insufficient.
7005 8570 The selected volume does not exist.
7005 8571 The volume is already defined as a
reserved volume.
7005 8572 The volume is already defined as a
P-VOL.
7005 8573 The volume is defined as a source
volume for Auto LUN.
7005 8574 The volume is defined as a target volume
for Auto LUN.
7005 8575 The selected volume is not a reserved
volume.
7005 8576 No reserved volume is available for use.
7005 8577 The number of reserved volumes to be
defined exceeds the maximum.
7005 8578 The P-VOL is already paired with a
backup volume. The P-VOL cannot be
paired with the target volume.
7005 8579 No volume is defined as a reserved
volume.
Recommended Action
Restore the blocked volume, then retry
the operation.
The system disk cannot be specified
as a reserved volume. Specify another
volume.
Wait until the volume is formatted, and
retry the operation.
Specify a volume that is not used as a
command device.
Please contact HP Technical Support.
Please contact HP Technical Support.
Check the contents, and retry.
Check the contents, and retry.
Please contact HP Technical Support.
Please contact HP Technical Support.
Please contact HP Technical Support.
Specify the volume of the supported
emulation type.
See the section "Planning number of
pairs" in the HP StorageWorks P9000
Business Copy User Guide for the
relation between the number of pairs that
can be created and the shared
memories.
Refresh the window, and retry the
operation.
Check the status of the volume.
Check the status of the volume.
Release the Auto LUN setting.
Release the Auto LUN setting.
Check the status of the volume.
Check the contents, and retry.
Stop the operation of the Reserve volume
setting, or delete the Reserve volume.
Check the contents, and retry.
Define the reserve volume, then retry the
operation.
Severity
Level
E
W
W
E
E
W
W
E
E
E
W
W
W
W
W
W
W
W
W
W
W
W
Part code 7005 237