HP StorageWorks P9000 Manual page 64

Table 26 Error codes (part code 01022) (continued)
Part Error
Code Number
01022 105025
01022 105026
01022 105027
01022 105028
01022 105029
01022 105030
01022 105031
01022 105033
01022 105037
01022 105038
01022 105040
01022 105041
01022 105042
01022 105043
01022 105044
64 Message (part code group 1nnn)
Error Message
The specified host name cannot be
added because it is already used in the
same port, or it exists in the [Selected
Hosts] table.
The processing cannot be done because
of no data in the [Selected Hosts] table.
[Detail] is clicked in the state that no row
is selected.
[Detail] is clicked in the state that multiple
rows are selected.
Host groups cannot be added in this
port, because the port is not Target or
RCU Target.
No more host group can be added,
because the number of registered host
groups that can be added to the subject
port has reached the maximum.
The host group cannot be added
because no row is selected in any of the
[Available Hosts] table and the
[Available Ports] table.
No more host group can be added,
because the number of registered hosts
that can be added to the subject port has
reached the maximum.
The specified name of the host group is
incorrect.
The default host group name cannot be
used for the host group setting.
[Detail] is clicked without selecting a
table row.
[Detail] is clicked in the state of selecting
multiple table rows.
[Delete] is clicked without selecting any
row.
The processing cannot be done because
there is no data in the [Selected Host
Groups] table.
[Detail] is clicked without selecting table
rows.
Recommended Action
Check the setting(s).
Check if there is a target host to be set
in the [Selected Hosts] table. When there
is not, add host(s) and retry the
operation. When there is, close the
window(s) and refresh it, then retry
again. If the same problem persists
despite retrying, please contact HP
Technical Support.
Select one table row.
Select one table row.
Check the setting(s).
Check the setting(s).
Select one or more rows in the [Available
Hosts] table and the [Available Ports]
table, then click [Add].
Check the setting(s).
Enter the host group name with up to 64
alphanumeric characters and symbols (\
/: , ; * ? "< > | are excluded).
Specify another host group name.
Select one table row.
Select one table row.
Select one or more table rows.
Check if any of target host group to be
set exists in the [Selected Host Groups]
table. When there is not, add host
group(s) and retry the operation. When
there is, close the window(s) and refresh
it, then retry again. If the same problem
persists despite retrying, please contact
HP Technical Support.
Select one table row.
Severity
Level
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W