HP StorageWorks P9000 Manual page 255

Table 62 Error codes (part code 7105) (continued)
Part Error Error Message
Code Number
7105 8539 There is insufficient shared memory to
create 4096 pairs.
7105 8540 There is sufficient shared memory to
create 4096 pairs, but initial subsystem
setup is required before creating pairs.
7105 8541 There is sufficient shared memory to
create 4096 pairs, and the initial
subsystem setup is complete.
7105 8542 Failed to complete the initial shared
memory setup.
7105 8543 The shared memory size is different.
7105 8544 16 Mbytes of shared memory is
available.
7105 8545 A power supply failure is detected.
7105 8546 The command was rejected. The PS OFF
is in progress.
7105 8547 A data transfer failure is detected (CHA).
7105 8548 A data transfer failure is detected (DKA).
7105 8549 The S-VOL is not implemented.
7105 8550 The command has been rejected,
because the specified S-VOL is blocked
or used as a system disk.
7105 8551 The S-VOL is being formatted.
7105 8552 This volume cannot be specified as an
S-VOL because it is used as a command
device.
7105 8553 The T-VOL is not implemented.
7105 8554 The command has been rejected,
because the specified T-VOL is blocked
or used as a system disk.
7105 8555 The T-VOL is being formatted.
7105 8556 This volume cannot be specified as an
T-VOL because it is used as a command
device.
7105 8557 The volume is not implemented.
Recommended Action
There is insufficient shared memory in
DKC. Please contact HP Technical
Support.
Please contact HP Technical Support.
Close the message box.
Please contact HP Technical Support.
Please contact HP Technical Support.
Check the contents, and retry.
Please contact HP Technical Support.
Retry the operation with power ON.
Please contact HP Technical Support.
Please contact HP Technical Support.
You cannot execute the operation for the
volume which is not implemented.
Restore the blocked volume, then retry
the operation.
The system disk cannot be specified
as an S-VOL. Specify another volume.
Wait until the volume is formatted, and
retry the operation.
As the S-VOL, specify a volume that is
not used as a command device.
You cannot execute the operation for the
volume which is not implemented.
Restore the blocked volume, then retry
the operation.
The system disk cannot be specified
as a T-VOL. Specify another volume.
Wait until the volume is formatted, and
retry the operation.
Release the command device, then retry
the operation.
You cannot execute the operation for the
volume which is not implemented.
Severity
Level
E
E
i
E
E
W
E
W
E
E
W
E
W
W
W
W
W
W
W
Part code 7105 255