HP StorageWorks P9000 Manual page 216

Table 55 Error codes (part code 6510) (continued)
Part Error
Code Number
6510 8101
6510 9006
6510 9009
6510 9021
6510 9024
6510 9025
6510 9026
6510 9100
6510 9101
6510 9102
6510 9104
6510 9105
6510 9106
6510 9107
6510 91 1 1
6510 91 12
6510 91 15
216 Message (part code group 6nnn)
Error Message
The system cannot apply the new
configuration. Do you want to refresh?
Exchange the channel cable connections
after confirmation of the port type.
The export is complete.
The Port Setting process has not
completed. Do you want to continue for
other ports?
Are you sure you want to exchange the
specified ports? Please confirm the
associated channel paths are off-line.
Are you sure you want to switch the
ports? If the remote copy paths exist on
the ports, delete them beforehand.
Are you sure you want to switch the
ports?
If any remote copy paths exist on the
ports, delete them beforehand.
Also, to avoid the switching operation
from being reported as a failure, confirm
first that a message prompting you to
change the channel cable connections
is displayed, and then perform the
necessary changes.
Do you want to exit?
Do you want to cancel?
Do you want to apply?
Do you want to change the mode?
The value that is under setup is not
reflected yet. Do you want to exit?
The value that is under setup is not
reflected yet. Do you want to change the
mode?
The value that is under setup is not
reflected yet. Do you want to continue
the operation?
Do you want to delete the specified line
of settings from the Preview list?
Do you want to continue this operation?
The monitoring was stopped by another
operator. The graph will be closed.
Recommended Action
Click [Refresh], and retry.
Check the port type, then change cable
connections.
Click [OK].
To continue processing, click [Yes]. If the
processing finishes, reconfigure the port
that is not in operation.
Ensure that the associated channel paths
are offline.
Remove the remote copy paths that are
associated with the ports.
To continue to change ports, click [OK].
To close the window, click [OK].
Otherwise, click [Cancel].
To cancel the operation, click [OK].
To apply settings in Preview to the disk
storage system, click [OK].
To switch the mode, click [OK].
Otherwise, click [Cancel].
To discard the current settings and close
the window, click [OK]. Otherwise, click
[Cancel].
To discard the current settings and switch
to View mode, click [OK]. Otherwise,
click [Cancel].
To discard the current settings and
refresh the window, click [OK].
Otherwise, click [Cancel].
To discard the current settings, click
[OK]. Otherwise, click [Cancel].
To continue the current operation, click
[OK]. Otherwise, click [Cancel].
Click [OK].
Severity
Level
W
i
i
i
i
i
i
i
i
i
i
W
W
W
W
i
i