Message (Part Code Group 2Nnn); Part Code 2005 - HP StorageWorks P9000 Manual

4 Message (part code group 2nnn)

This chapter includes the error messages with the part code 2005 and 2010.

Part code 2005

Table 29 Error codes (part code 2005)
Part Error
Code Number
2005 1002
2005 1006
2005 1009
2005 1010
2005 1012
2005 1013
2005 1015
2005 1021
2005 1028
2005 1050
2005 1 126
Error Message
The specified volume cannot be set as a
command device or a component of a
LUSE volume, because it is being used
as the volume of Remote Copy, Business
Copy, Auto LUN, or Snapshot.
The specified LUSE volume cannot be
released, because it is being used as the
volume of Remote Copy, Business Copy,
Auto LUN, or Snapshot.
The emulation type of the volumes is not
for open systems, or the volumes are not
mounted.
An error occurred during SVP
processing.
LU path is set to a volume which links as
an expanded LU.
The emulation types of the volumes
combined into a LUSE volume are not
the same.
LU path is set to the releasing expanded
LU. (You need to release the expanded
LU and path at the same time.)
The specified volume does not exist.
The number of volumes you intend to
combine into a LUSE volume exceeds the
maximum.
The following volumes cannot be
specified when you change the
expanded LU configurations:
Volumes that do not exist
Volumes reserved by Auto LUN
System Disk volume
The LUSE operation cannot be performed
because the volume is set as a command
device.
Recommended Action
Select another volume.
Select another volume.
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
If this problem persists, please contact
HP Technical Support.
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
The configuration information has been
changed already.
Check the settings, and request the
configuration information setting again.
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
Check the settings, then retry the
operation.
Correct the specified contents, then retry
the operation.
Severity
Level
W
W
W
W
W
W
W
W
W
W
W
Part code 2005 73