Switchcfgspeed - Brocade Communications Systems 8 Command Reference Manual

2

switchCfgSpeed

switchCfgSpeed
Configures the speed for all ports on a switch.
Synopsis switchcfgspeed speed
Description Use this command to configure the port speed on a switch. This command sets the speed for all
user ports. If any port on the switch is not capable of the specified speed setting, an error message
is displayed for that port. The configuration is saved in nonvolatile memory and persists across
switch reboots or power cycles.
Use the portShow command to display actual port speed settings. Use the portCfgShow command
to display user-configured speed settings.
Notes This configuration cannot be set on VE_Ports or VEX_Ports.
Speed configuration is not applicable to FCoE ports.
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands This command has the following operand:
speed
Examples To set the autosensing mode for all ports on a switch:
See Also portCfgSpeed, portShow
924
Specifies the speed for all ports on a switch. This operand is required. Valid
values are as follows:
0 Autosensing mode. The port automatically configures for the highest
speed.
1 The port is set at a fixed speed of 1 Gbps.
2 The port is set at a fixed speed of 2 Gbps.
4 The port is set at a fixed speed of 4 Gbps.
8 The port is set at a fixed speed of 8 Gbps.
switch:admin> switchcfgspeed 0
Committing configuration...done.
Fabric OS Command Reference
53-1001764-02