Brocade Communications Systems 8 Command Reference Manual page 349

CRP PID CHID
Examples To enable FMS mode for the switch:
To set the ASM bit in the mode register for the switch:
To set the MIHPTO value to 60 seconds:
To set the current reporting path:
To display the current reporting path:
See Also ficonCupShow
Fabric OS Command Reference
53-1001764-02
Sets the current reporting path (CRP). The reporting path is a CUP
mechanism for sending FRU-failure reports to a FICON logical path via FICON
protocol. The logical path between the PID and the CHID must exist and be in
operational state for this command to succeed. Use ficonCupShow with the
LP option to display the logical paths on the switch. The following operands
are required:
PID Specifies the Port identifier.
CHID Specifies the Channel ID (CHID). The CHID is the Logical Partition (LPAR)
identifier supplied as part of the FICON protocol header. The format of the
CHID is a numerical identifier followed by a letter, for example, 1B.
switch:admin> ficoncupset fmsmode enable
fmsmode for the switch is now Enabled
switch:admin> ficoncupset modereg ASM 1
Active=Saved Mode bit is set to 1
switch:admin> ficoncupset MIHPTO 60
MIHPTO has been changed to 60 seconds
switch:admin> ficoncupset CRP 082300 1A
switch:admin> ficoncupshow LP
FICON CUP Logical Paths for CUP 0x08FE00
LP Reporting
PID CHID State
------ ---- ----
082300 1A Oper***
082300 1B Oper
082300 1C Oper
082400 1A Reset
082400 1B Reset
612400 1E Reset
612400 1F Reset
Path
------
Curr
Prim
2
ficonCupSet
317