Ficoncupshow - Brocade Communications Systems 8 Command Reference Manual

2

ficonCupShow

ficonCupShow
Displays FICON-CUP parameters for a switch.
Synopsis ficoncupshow fmsmode
ficoncupshow modereg [bitname]
ficoncupshow MIHPTO
ficoncupshow LP
Description Use this command to display FICON-CUP (Control Unit Port) parameters for a switch.
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details
Operands This command has the following operands:
fmsmode
modereg
MIHPTO
LP
Examples To display the FMS mode for the switch:
318
Display the FICON Management Server (FMS) mode for the switch.
Display the FICON-CUP mode register. If no operand is specified, all mode
register bit settings are displayed. If a mode register bit name is specified,
then only the value of that bit is displayed. A value of 1 indicates that a given
mode register bit is set, and 0 indicates that it is not set.
The following operand is optional:
bitname Displays the specified mode register bit as either set (1) or not set (0). Valid
values for bitname are:
POSC Programmed offline state control
UAM User alert mode
ASM Active=saved mode
DCAM Director clock alert mode
ACP Alternate control prohibited
HCP Host control prohibited
Displays the FICON-CUP missing interrupt handler primary timeout (MIHPTO)
value in seconds.
Displays the logical paths on the switch. For each entry, the command
displays the port identifier (PID), the LPAR identifier (CHID), reporting state
(operational or reset (=nonoperational)), and path (current or primary).
switch:user> ficoncupshow fmsmode
fmsmode for the switch: Enabled
Fabric OS Command Reference
53-1001764-02