Porttestshow - Brocade Communications Systems 8 Command Reference Manual

portTestShow

Displays information from portTest.
Synopsis porttestshow [-ports itemlist]
Description Use this command to display a snapshot of information from portTest. The command output
displays statistical data about past test runs and values for parameters that were set when the test
was run. Refer to the portTest help page for more information on the displayed parameters. The
output includes the following information:
Port number
PortType
PortState
PortTypeToTest
Pattern
Seed
UserDelay
TotalIteration
CurrentIteration
TotalFail
ConsecutiveFail
StartTime
StopTime
Timeout
ErrorCode
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands This command has the following operand:
-ports itemlist
Fabric OS Command Reference
53-1001764-02
Displays test status for the port. Values are PASS or FAIL.
Type of port tested.
Current State of portTest. Values are NO TEST, TESTING, or TEST DONE.
Groups of ports tested: Values are ALL_PORTS, ALL_E_PORTS, ALL_L_PORTS,
ALL_F_PORTS, ALL_LB_PORTS, or SINGLE_PORT.
The pattern of the test packets payload.
The seed value used with the selected pattern. The default seed value is
0xaa.
The delay between frames sent by portTest in milliseconds. The default value
is 10 milliseconds.
Total number of test iterations.
Current test iteration.
Total number of failed tests.
Number of consecutive failed tests.
portTest start time.
portTest end time.
Number of timed out tests.
Error code, if any.
Displays test results for the specified ports. This operand is optional; if
omitted, data for all ports are displayed. Refer to the itemList help page for
further details.
2
portTestShow
801