Brocade Communications Systems 8 Command Reference Manual page 170

2
configure
Zoning Operation Parameters
Table 9
TABLE 9
Field
Disable NodeName Zone Checking
Disable NodeName Zone Checking
RSCN Transmission Mode
Table 10
TABLE 10
Field
End-device RSCN Transmission Mode
Domain RSCN to End-device for switch IP address or name change
End-device RSCN Transmission Mode values are as follows:
Domain RSCN to End-device for switch IP address or name change values are as follows:
Arbitrated Loop Parameters
The Arbitrated Loop Setting fields are described in
TABLE 11
Field
Send FAN frames?
Enable CLOSE on OPEN received?
Always send RSCN?
Descriptions of the Arbitrated Loop Parameter fields are as follows:
Send FAN frames?
138
lists the configurable zoning operation parameters.
Zoning operation parameters
Specify 1 to disable using node WWN when specifying nodes in the zone
database, or specify 0 to enable using node WWN when specifying nodes in
the zone data. The default value is 0. This value must be set to 1 for
interpretability.
lists the RSCN transmission mode values fields.
RSCN transmission modes
0 RSCN only contains single PID
1 RSCN contains multiple PIDs
2 Fabric addresses RSCN
0 Disabled. No domain RSCN is sent to the end-device for the switch IP address
or name change.
1 Enabled. Domain RSCN is sent to the end-device for the switch IP address or
name change.
Configure command arbitrated loop settings
Specifies that fabric address notification (FAN) frames be sent to public loop
devices to notify them of their node ID and address. When set to 1, frames
are sent; when set to 0, frames are not sent.
Type Default
Boolean 0
Type
number
number
Table 11.
Default
1
4
0
Range
1
Default Range
1 0 to 2
0 0 to 1
Range
0 or 1
0 to 4
0 or 1
Fabric OS Command Reference
53-1001764-02